adccommunitymod (AutomationDirect) asked a question.
Created Date: February 21,2013
Created By: m_celectric
**** This post has been imported from our legacy forum. Information in this post may be outdated and links contained in the post may no longer work.****
Simple question I have established comm between master and slave all green run lights. I only have 1 slave with 16 in and 16 out. I have addressed them to x100 and y100. My problem is I am not seeing them respond in my data view. I have wrote the logic according to the manual example using 3 slaves. I improvised removing slave 2 and 3 adding Store to shared memory rung to the end of slave 1 group. Does anyone have suggestions or examples of 1 slave logic. Tech support said i need to set all slaves to zero. does this mean i have to write the logic for all available
Created Date: February 21,2013
Created by: Do-more PE
The setup must match the hardware exactly. It is not forgiving at all.
Created Date: February 21,2013
Created by: m_celectric
Simple question I have established comm between master and slave all green run lights. I only have 1 slave with 16 in and 16 out. I have addressed them to x100 and y100. My problem is I am not seeing them respond in my data view. I have wrote the logic according to the manual example using 3 slaves. I improvised removing slave 2 and 3 adding Store to shared memory rung to the end of slave 1 group. Does anyone have suggestions or examples of 1 slave logic. Tech support said i need to set all slaves to zero. does this mean i have to write the logic for all available