adccommunitymod (AutomationDirect) asked a question.
Click Connection Problems
Created Date: December 08,2013
Created By: building2
**** This post has been imported from our legacy forum. Information in this post may be outdated and links contained in the post may no longer work.****
I can't get a connection to my Cllick plc (I use it for training purposes in a Facilities class I teach) and I'm suspecting a programming cable failure. Does anyone know how I can check the cable before I purchase a new one or any other ideas regarding the connection problem. Thanks in advance.
Created Date: December 09,2013
Created by: Mike@Forshock
Continuity test, "Ohm it out " ;)
Created Date: December 14,2013
Created by: LWgreys
Are you using the PC's serial port or are you using a USB to serial device. If your using the USB device, did you install the Koyo USB Serial Driver for Click when installing the software?
See page 11 of the software installation manual. Read Note: (NOTE: You can use either a USB port or a serial port to program the CLICK PLC. You must install this USB driver if you use a USB port. You do not have to install it to use a serial port.)
Created Date: December 08,2013
Created by: building2
I can't get a connection to my Cllick plc (I use it for training purposes in a Facilities class I teach) and I'm suspecting a programming cable failure. Does anyone know how I can check the cable before I purchase a new one or any other ideas regarding the connection problem. Thanks in advance.