adccommunitymod (AutomationDirect) asked a question.
ST142 error on upload
Created Date: October 19,2015
Created By: pioplastic
**** This post has been imported from our legacy forum. Information in this post may be outdated and links contained in the post may no longer work.****
When I upload changes to a DoMore program, I get a warning error ST142 (driver load error) and after I clear the warning, it does not reappear until I upload new program changes. Can I find out which driver is causing the problem? Using DoMore Designer v1.4.3
Created Date: October 19,2015
Created by: plcnut
I'm not sure on your error, but do you have the latest firmware in your PLC Processor?
Created Date: October 20,2015
Created by: BobO
You 're more than likely not running the latest firmware. There were new device types added to 1.4 that earlier firmware doesn't recognize. We don't report the driver specifics because there is nothing you can do to change it other than update the firmware.
Created Date: October 24,2015
Created by: pioplastic
Thanks for reminding me on the firmware. I was running an older version. Updated the firmware and problem solved.
Created Date: October 19,2015
Created by: pioplastic
When I upload changes to a DoMore program, I get a warning error ST142 (driver load error) and after I clear the warning, it does not reappear until I upload new program changes. Can I find out which driver is causing the problem? Using DoMore Designer v1.4.3