adccommunitymod (AutomationDirect) asked a question.
Changing IP address on C-More panels
Created Date: May 03,2013
Created By: div_by_zero
**** This post has been imported from our legacy forum. Information in this post may be outdated and links contained in the post may no longer work.****
Is there a way to allow an operator to change the IP address from the screens of a C-More panel, or must this be "hardcoded " back at the shop? Thanks.
Created Date: May 03,2013
Created by: Do-more PE
Press the upper left corner of the screen for ten seconds. Say Yes to the next prompt. Select Settings and again hold the upper left corner.
The IP address setting dialog should be displayed. Enter the correct IP address, subnet and gateway if required. Be sure to press the ENT key after each setting is entered.
Created Date: May 03,2013
Created by: div_by_zero
Press the upper left corner of the screen for ten seconds. Say Yes to the next prompt. Select Settings and again hold the upper left corner.
The IP address setting dialog should be displayed. Enter the correct IP address, subnet and gateway if required. Be sure to press the ENT key after each setting is entered.
Excellent, thanks! Good stuff there.
Created Date: May 03,2013
Created by: div_by_zero
Is there a way to allow an operator to change the IP address from the screens of a C-More panel, or must this be "hardcoded " back at the shop? Thanks.