adccommunitymod (AutomationDirect) asked a question.
Gui-155
Created Date: February 12,2013
Created By: a agnone
**** This post has been imported from our legacy forum. Information in this post may be outdated and links contained in the post may no longer work.****
I tried to read from file a project I saved to disk and get the GUI-155-Unsuppoeted file version. What is that! I am now reading right from the panel. What good is saving to disk if I get that massage. Help please. The help file does not explain it.
Created Date: February 12,2013
Created by: Bob S BN
Just grabbing at straws here with the limited info...
Are we talking CMORE, MICRO, other?
Assuming CMORE...
Is the saved file from the same software, or an EZtouch? Is it AD's EZtouch, or EZautomation's?
More info please
Created Date: February 12,2013
Created by: Do-more PE
Typically GUI-155 happens when you save a project with a newer version of the programming software than what you are trying to open the file with.
IE you save with version 2.77, but are trying to open it with version 2.75.
Created Date: February 12,2013
Created by: a agnone
Sorry, forgot it is a micro. I been using the same software for awhile now. I did read from panel then save it to disk, then read from disk okay this time. When I saved it the second time, it saved without saying there was a difference in software versions. I will close the program and try it again. If it gives me the message again. I will post.
Created Date: February 12,2013
Created by: a agnone
I tried to read from file a project I saved to disk and get the GUI-155-Unsuppoeted file version. What is that! I am now reading right from the panel. What good is saving to disk if I get that massage. Help please. The help file does not explain it.