adccommunitymod (AutomationDirect) asked a question.
DL-06 PSU wanted
Created Date: July 16,2016
Created By: simmasr
**** This post has been imported from our legacy forum. Information in this post may be outdated and links contained in the post may no longer work.****
Dear all, It happened, that the DL-06 PSU ES-V4431 has died. I have tried to search for a replacement, but unluckily. So I need a little help from you. I need to get the exact voltage measures suppled from ES-V4431 PSU to the PLC board. By having this information, I will try to replace the original power supply with analog. I know, it will be odd, but I need to extract the important data from the PLC memory.
Created Date: July 16,2016
Created by: simmasr
Dear all,
It happened, that the DL-06 PSU ES-V4431 has died. I have tried to search for a replacement, but unluckily. So I need a little help from you. I need to get the exact voltage measures suppled from ES-V4431 PSU to the PLC board. By having this information, I will try to replace the original power supply with analog. I know, it will be odd, but I need to extract the important data from the PLC memory.
Created Date: July 18,2016
Created by: simmasr
annyone can help here?
Created Date: July 19,2016
Created by: johnaden
I have a DL06 opened up. Not sure where to check power supply voltages.
Created Date: July 20,2016
Created by: ControlsGuy
If the data is so critical you'd be willing to repair or replace the power supply, I know where you can buy one. Every 06 comes with one built in!
Created Date: July 21,2016
Created by: johnaden
Where are you located?
Created Date: July 21,2016
Created by: simmasr
Lithuania, Europe.
Created Date: July 21,2016
Created by: johnaden
Please send a larger picture.
Created Date: July 26,2016
Created by: simmasr
Could anyone measure voltages on these points with highlighted circle, while PSU is in operation? I have attached pictures to the post.
n102078 n102079
Created Date: July 26,2016
Created by: Szarman
I'm sure someone can provide you with the voltages, but I would recommend not hooking up a different power supply to it. I would just buy another DL06 and swap the power supplies. The voltages that are generated are more than likely sequenced a certain way, also i would imagine one of those signals on the wire is a reset/power good signal. To get it all to work is definitely possible, but might require a working power supply and a scope to capture the power sequence, and signal levels then creating something to emulate it. If it not done properly, you risk the possibility of damaging the CPU/base/modules.
Edit: Did you check the fuse? It is the red part on the lower left corner.
Created Date: August 03,2016
Created by: johnaden
Here's my measurements In order -
Black wire: (Reference) Ov,
black wire, +5 vdc,
black wire 0 vdc,
black wire o vdc ,
brown wire +5 vdc,
brown wire +5 vdc.